Beninca PONY Manual De Instrucciones página 19

Ocultar thumbs Ver también para PONY:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fixing the end run brackets
Stopping the movement, in the opening phase and in the clos-
ing phase, takes place via the end run brackets FRD.1, which,
relevantly fixed onto the rack, make the end run spring, present
on the gear motor, intervene.
To position and fix the brackets FRD 1, proceed as follows:
1 -Take the leaf to the desired opening position. If a stop block
is present on the ground, the leaf must stop 2/3 cm before the
block (Figure 20).
2 - Place the right bracket FRD.1 on the rack and make it slide
until the end run spring, bending, effects switch-over of the inter-
nal switch, which can be perceived with a "click" (Figure 21).
3 - Fix the bracket temporarily via the two screws supplied
(Figure 22).
4 - Take the leaf into the completely closed position and then
open by about 2 cm (Figure 23).
2/3 cm
5 - Place the left bracket FRD.1 on the rack and make it slide until
the end run spring, bending, effects switch-over of the internal
switch, which can be perceived with a "click" (Figure 24).
6 - Fix the bracket as indicated in previous point 3.
7 - If necessary, use a hacksaw to shorten the end part of the
last tract of the rack, so that it does not project with respect to
the plumb line of the leaf.
In the inspection phase, use several opening and closing
manoeuvres to check whether the end run intervenes
in the correct opening and closing points, before the
respective mechanical profiles.
If necessary, move the brackets FRD.1 to advance or
delay the stop points
Fig. 20
Fig. 21
CLICK!
2/3 cm
2/3 cm
¡CLIC!
CLICK!
8 - When the best stop points have been established, remove
the two screws, and use a drill (45 mm point), to make the holes
with depth of about 2 mm in correspondence with the signs left
by the screws and then fix bracket FRD.1 again (Figure 25).
A seat for the screws is created in this way, which guarantees
the stability of the bracket FRD.1 on the rack.
Fig. 22
2/3 cm
Fig. 23
2/3 cm
¡CLIC!
CLICK!
2/3 cm
CLICK!
Fig. 25
CLICK!
2/3 cm
2/3 cm
Fig. 24
CLICK!
CLICK!
2
19

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pony 115

Tabla de contenido