Accessory - Dantherm HCC 2 ALU Manual De Servicio

Accessory

Introduction
Electric preheating
Hand held Remote
control
Wired Remote
Control
(HCP 10/11)
Accessory control
(HAC 2)
VOC and humidity
sensors
Filters
10
The unit is delivered from factory, without any accessories mounted. These are to be installed
prior to initial unit installation or alternative after commissioning, if further functionality is
requested. The detailed installation of one or more accessories, is illustrated on the leaflet fol-
lowing each accessory .
The unit can be equipped with an electrical preheating element that preheats the incoming
air. The preheater increases the outside air temperature going into the heat exchanger, and
thereby reduces the risk of ice in the heat exchanger in very cold conditions.
The preheater is an external enclosure, connected and controlled by the HCC 2 controller.
For controlling HCC 2 units,
Dantherm recommends using the
display equipped remote control,
designed specific for this range of
units.
A wired remote control (HCP 10/11) without display can be
connected to the unit as an alternative to the hand held remote
control.
Connect a number of additional accessories to the
HCC 2 unit via an accessory controller: HAC 2.
HCC 2 can be fitted with Humidity (RH%) (if
not already included as standard) and/or VOC
(organic chemicals) sensors. These sensors will
continuously monitor the extract air, and adjust
the air flow level accordingly. This will result in
adequate level of ventilation, with lowest pos-
sible electrical power consumption. If a remote
control is connected, the sensor level will be
shown in the display using 3 level icon.
Replacement of filters in sets of 2 standard filters or 1 standard plus 1 F7 (pollen) filter.
Product description: Accessory
AUTO
* *
CO 
2
°
RH%  °
°
Fig. 5
RH%
°
Ikoner for manual
Fig. 6
Fig. 7
VOC
Fig. 8