Product Description; Overall Description; Product Illustration - Dantherm HCC 2 ALU Manual De Servicio

Overall description

Introduction

Product illustration

Part description
6

Product description

HCC 2 residential ventilation unit is designed to supply fresh air to residential home, by ex-
changing heat from outgoing air to incoming air, resulting in low heat energy loss.
These units are designed for installation underneath a ceiling, in dry surroundings, with tem-
peratures >12°C. e.g. utility room or similar heated rooms.
The duct connections can be electronically swapped, providing ability to route the connected
ducts, either to the right or to the left, as described on page 15
This illustrates the unit, without the steel drip tray:
1
7
8
9
13
This table shows the parts according above illustration:
Pos Mode A(default)
1 Extract filter G4
2
3
4
5
6 Supply filter G4 or F7
7 Extract air - T3
8
9 Supply air - T2
10 Outside air - T1
11 Water drainage spigot
12 Exhaust air – T4
13
14
15
*Accessory
2 3 4
14
Fig. 1
Bypass module*
USB connection
Mode switch A / B on the side panel
Controller PCB (external connections see page 21)
Blocked
Extract fan
Heat exchanger
Supply fan
Product description: Overall description
6
5
15
Mode B
Supply filter G4 or F7
Extract filter G4
Outside air - T1
Water drainage spigot
Exhaust air-T4
Extract air - T3
Blocked
Supply air - T2
Supply fan
Extract fan
10
11
12