Adjustments - Scotsman C0322 Manual De Instalación Y Del Usuario

Adjustments

Bridge Thickness - For the Service Tech Only
1. Push and hold Off till the machine stops.
2. Remove evaporator cover.
3. Remove curtain.
4. Use a hex wrench and rotate the bridge
thickness adjustment screw in 1/8 turn
increments CW to increase bridge thickness.
Rotate CCW to decrease bridge thickness.
Caution: Do not make the bridge too thin or the
machine will not harvest properly. Bridge thickness
adjustments are not covered by warranty.
5. Return curtain and evaporator cover to their
normal positions.
6. Push and release the On button. Check next
harvest of ice. Repeat steps 1-6 if needed.
Water Purge Setting
The water purge is factory set to the automatic
position, suitable for most water conditions. The
setting can be changed to one of 5 manual settings
or left on automatic.
Purge
1 - Minimum
setting
Water RO water or
Type equivalent
To set:
1. Switch the machine OFF by holding the Off
button in until a number or the letter A shows
on the display.
2. Press and release the On button repeatedly
until the number on the display corresponds to
the desired setting.
3. Press and release the Off switch again to
return to the normal control state.
2 - 3 -
Moderate Standard
Low TDS Use for
non - RO typical
water water
July 2006
Air and Water Cooled User Manual
Note: Indentations may be deeper on C0322 and C0330
1/8" indentation
1/8-3/16"
bridge
Too Big
Just Right
Ice Bridge Thickness Measurement
Bridge Thickness Adjustment Mechanism
4 - Heavy 5 - Maximum
High TDS Very High
water TDS water
Note: Water cooled models, the refrigeration
system discharge pressure is factory set at 245
PSIG, which should yield a freeze cycle discharge
water temperature of about 40-43 degrees C.
Adjust if necessary.
C0322 through C1030
Too Small
Adjustment
Screw
A - Automatic
Any with
conductivity not
less than 10
microSiemens/cm