Tips And Recommendations; Questions About The Sunea Io; Replacing A Lost Or Broken Somfy Io Control Point - SOMFY Sunea io Guia De Instalacion

To activate this function:
1) Set the awning to the halfway position.
2) Briefly press the "my" and Up buttons simultaneously ,
then immediately press and hold simultaneously the "my"
and Up buttons until the awning makes a movement.
The motor is in programming mode for only
seconds.
3) Adjust the closing force using the Up or Down button.
- To increase the closing force, press the Up button until
the awning makes a slow movement: the cassette
awning's closing force has moved up a level.
- To decrease the closing force, press the Down button until the store makes a slow movement: the
cassette awning's closing force has moved down a level.
4) Press the "my" button until the awning makes a movement: The new closing force has been
programmed.

8. TIPS AND RECOMMENDATIONS

8.1. Questions about the Sunea io?

Observations
The awning does
The wiring is incorrect.
not work.
The motor is hot.
An incorrect cable has been used.
The Somfy io control point battery is
weak.
The control point is not compatible.
The Somfy io control point used has not
been programmed into the motor.
The awning stops
The crown is incorrectly positioned.
too soon.
The end limits have been incorrectly set. Readjust the end limits

8.2. Replacing a lost or broken Somfy io control point

Refer to the corresponding guide.
Copyright © 2010 Somfy SAS. All rights reserved.
Possible causes
1
ou
10
3
or
Solutions
Check the wiring and modify it if
necessary.
Wait until the motor cools down.
Check the cable and ensure it has 3
leads.
Check if the battery is weak and replace it
if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed io control point or
program this io control point.
Fit the crown correctly.
Sunea io
2
0,5 sec 5 sec
4
9