Replacement Of A Lost Remote Control; Adding/Deleting Rts Transmitter - SOMFY Sonesse 50 RTS Guia De Instalacion

7.3. Replacement of a lost remote control

This reset deletes all transmitters programmed, but
end-limits, intermediate position and sensors are
retained.
Only switch off the current for the motor to be reset!
1) Cut the power supply for 2 seconds.
2) Switch the power supply back on for 10 to 15
seconds.
3) Cut the power supply for 2 seconds.
4) Switch the power supply back on: the shade moves
during 5 seconds (If the shade position is an end limit,
the behavior of the shade will be a jog).
5) Press the RTS transmitter (B) PROG button until the
shade jogs: all the RTS transmitter are cleared and the
new RTS transmitter is programmed in the motor.

7.4. Adding/deleting RTS transmitter

Find a RTS transmitter programmed in the motor.
Press and hold the programmed RTS transmitter's
(A) PROG button until the shade jogs: the motor is in
programming mode.
Press briefly the RTS transmitter (B) PROG button to
add or delete this transmitter: the shade jogs and the
RTS transmitter is programmed or deleted from the
motor.
10
1
3
5
PROG.
B
+
-
PROG.
© 2013 Somfy SAS. All rights reserved. 12/2013
2
10 to 15
2 sec
sec
4
2 sec
A
PROG.
PROG.
A B
PROG.
PROG.
A B
C
PROG.
C
A
C C