Technical Data; Orbital-Action Jig Saw - Hilti WSJ 750 Manual Del Usuario

Status
Position 1
Position 2
Position 3
3.7 Anti-splinter insert
The product can be equipped with an anti-splinter insert.
The anti-splinter insert helps prevent splintering on the surface of wood materials when cutting.
3.8 Dust extractor with dust removal system
The dust extractor reduces dust emissions, increases working safety by providing better visibility of the
cutting line and reduces exposure to dust and wood chips at the workplace.
Always connect the dust removal system to the suction adapter when working over a lengthy period with
wood or materials that can cause high dust concentrations.
The guard must be installed if you work with a dust removal system.
3.9 Items supplied.
Orbital-action jig saw, saw blade, anti-splinter insert, dust removal adapter, slider, hex key, guard, operating
instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

4.1

Orbital-action jig saw

For rated voltage, rated current, frequency and/or input power, refer to the country-specific rating plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the device. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the device.
Weight in accordance with
EPTA procedure 01/2003
Operating temperature
Storage temperature
Maximum cutting depth for
structural steel
Maximum cutting depth for
wood
4.2 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
*377834*
WSJ 750-ET WSJ 750-EB
2.8 kg 2.6 kg
−17 ℃ ... 60 ℃ −17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃ −20 ℃ ... 70 ℃
10 mm 10 mm
120 mm 120 mm
377834
Meaning
Low orbital action
Medium orbital action
High orbital action
WSJ 850-ET
2.7 kg
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
10 mm
150 mm
WSJ 850-EB
2.6 kg
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
10 mm
150 mm
English 19