Fein WSG10-115T Manual Del Usuario página 19

3 41 01 121 21 0.book Seite 19 Montag, 22. August 2011 1:11 13
Working instructions.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
First check that the mains sup-
WARNING
ply lead and mains plug are
not damaged.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
WSG10T/WSG14T: Press the locking but-
ton only when the motor is stopped.
Starting (Figure 9).
After inserting the mains plug, the angle grin-
der can be started in any working position by
pressing the pressing surfaces twice in succes-
sion.
Hold the angle grinder in the required
working position, either at the
back (START A) or front (START B);
lightly press at least one of the 4 pressing
surfaces, and keep it/them pressed.
Please note: The accessory begins to move
with short, low-power impulses. The angle
grinder thereby indicates that the first pres-
sing surface has been activated.
For the working position holding the power
tool at the back (START A):
Briefly press one of the front switch-
pads (close to the auxiliary handle) with
your thumb.
For the working position holding the power
tool at the front (START B):
Briefly press one of the rear switch-
pads.
The angle grinder starts gently and rea-
ches its working speed after a short time.
Please note: The angle grinder does not start
up:
– when the switchpads at the front and rear
are pressed at the same time
– when the rapid-clamping lever is not tilted
back and engaged
– if one or more of the pressing surfaces is/
are pressed while the mains plug is inserted
en
19
Fig. 9