Fein WSG10-115T Manual Del Usuario página 20

3 41 01 121 21 0.book Seite 20 Montag, 22. August 2011 1:11 13
en
20
Setting the speed (Figure 10)
WSG14-70ET.
The speed can be set to different levels.
To increase the speed:
Briefly press button.
Reducing the speed:
Keep button pressed down.
The speed set is shown by the symbols on the
speed display.
The last speed setting used is stored in the
power tool after stopping the motor or after
pulling out the mains plug from the mains
socket.
The speed can be preset when the
mains plug is inserted, also when the
motor is at a standstill.
Operation (Figure 11).
Continuously press one of the 4
switchpads. The angle grinder is kept at
working speed.
Notes: The switchpads actuate easily in order
to prevent tense working postures. Changing
the working posture is possible at any time by
changing the switching position. The angle
grinder can be brought up to the working
speed again within 1.5 seconds by pressing
one of the 4 switchpads.
Fig. 10
3500/min
4200/min
3000/min
2500/min
Speed regulation
button
7000/min 5900/min
5000/min
4200/min
The self-start lock prevents the angle grinder
from automatically restarting again, even after
a brief interruption of the power supply, e.g.,
from a pulled mains plug.
Fig. 11
5900/min 7000/min
5000/min
Speed display
3500/min
3000/min
2500/min