Fein WSG10-115T Manual Del Usuario página 22

3 41 01 121 21 0.book Seite 22 Montag, 22. August 2011 1:11 13
en
22
Grinding (Figure 14).
Keep to an angle of tilt of 20 – 40°. In
this way you will obtain a good removal.
Press the power tool on evenly and
move it over the surface.
Do not allow the surface of the work-
piece to become too hot.
Cutting (Figure 15).
Always work against the direction of
rotation so that the cutting wheel does
not jump out of the cut.
Fig. 14
20°– 40°
Fig. 15