Peavey TransTube 100 EFX Manual Del Usuario página 13

Power Amplifier Section:
Power measured with power switch @ 100%
(5% THD, 1 kHz, 120 VAC line)
Rated Power and Load:
100 W RMS into 16, 8 or 4 Ohms
Frequency Response:
+0, -3 dB 100 Hz to 20 kHz @ 65 W RMS into 8 Ohms
Hum and Noise:
Greater than 90 dB below rated power
Power Consumption:
Domestic: 300 W @ 60 Hz, 120 VAC
Export: 300 W @ 50/60 Hz, 220-230/240 VAC
Preamp Section:
Preamp specs measured @ 1 kHz with controls preset
as follows:
Channel Select – Clean
Clean Mode Switch – Modern
Low and High EQ – 10
Mid EQ – 0
Lead Pre and Post Gain – 10
Lead Mode Switch – Vintage
Effects – Off
Nominal Levels – Clean Volume @ 5
Minimum Levels – Clean Volume @ 10
Preamp High Gain Input:
Impedance: High Z, 250 k Ohms
Nominal Input Level: -14 dBV, 200 mV RMS
Minimum Input Level: -23 dBV, 68 mV RMS
Maximum Input Level: 0 dBV, 1 V RMS
Preamp Low Gain Input:
Impedance: High Z, 44 k Ohms
Nominal Input Level: -8 dBV, 400 mV RMS
Minimum Input Level: -17 dBV, 136 mV RMS
Maximum Input Level: +6 dBV, 2 V RMS
TRANSTUBE
®
Features and specifications subject to change without notice.
100 EFX SPECIFICATIONS
Effects Send:
Load Impedance: 1 k Ohms or greater
Nominal Output Level:
Effects Level Switch "Out": -10 dBV, 0.32 V RMS
Effects Level Switch "In": 0 dBV, 1 V RMS
Effects Return:
Impedance: High Z, 22 k Ohms
Effects Level Switch "Out": -10 dBV, 0.32 V RMS
Effects Level Switch "In": 0 dBV, 1 V RMS
Preamp Output:
Load Impedance: 1 k Ohms or greater
Nominal Output Level: 0 dBV, 1 V RMS
Power Amp Input:
Impedance: High Z, 22 k Ohms
System Hum and Noise @ Nominal Input Level:
(20 Hz to 20 kHz unweighted)
Greater than 78 dB below rated power
Equalization:
Clean Channel:
Special Low, Mid, and High passive EQ
Modern/Vintage Switch: Two distinct EQ and
Gain voicings
Lead Channel:
Low, Mid, and High passive EQ
Vintage/Modern/High Gain Switch: Three different
EQ voicings
Dimensions:
11" H x 26.5" W x 11" D
(279 mm H x 673 mm W x 279 mm D)
Weight:
39 lbs. (17.7 kg)
13