Peavey TransTube 100 EFX Manual Del Usuario página 6

( ( 1 1 0 0 ) ) P P O O S S T T G G A A I I N N
This control sets the overall gain of the Lead channel.
( ( 1 1 1 1 ) ) C C H H A A N N N N E E L L S S E E L L E E C C T T
This switch selects the channel (Lead or Clean). The ACTIVE CHANNEL LEDs (6) indicate the active
channel — green for Clean; red for Lead.
( ( 1 1 2 2 ) ) E E F F X X A A D D J J U U S S T T
Pressing this control selects the effect. A yellow LED adjacent to the effect name will illuminate to
indicate the selected effect. Rotating this control clockwise changes the parameter of the active
effect according to the descriptions below. The surrounding LED ring indicates relative value of
the parameter being adjusted.
EFX ADJ PARAMETERS
Tremolo - Rate increase
Octaver - Wet/Dry mix
Flanger - Rate increase
Chorus - Rate increase/depth decrease
EFX amps are built with factory settings loaded into the presets. To return to the factory settings,
press and hold both the EFX ADJUST (12) and DELAY (14) controls while turning the amp on.
( ( 1 1 3 3 ) ) R R E E V V E E R R B B
This control adjusts the overall reverb level. The surrounding LED ring indicates level.
( ( 1 1 4 4 ) ) D D E E L L A A Y Y
This control adjusts delay type, time, and volume. Three types of delay are available: SLAP
(1 repeat), ECHO (3-4 repeats), or INFINITE (5-6 repeats). The LEDs in each section of the control
indicate which type is active and volume level. Pressing the control twice sets the delay time to
the interval between presses.
( ( 1 1 5 5 ) ) P P O O W W E E R R S S W W I I T T C C H H
This switch applies power to the unit in the "ON" position. One of the ACTIVE CHANNEL LEDs (6)
will illuminate to indicate that the unit is on. Pressing the lower portion of the switch turns the
unit off.
Funk Wah - Sensitivity increase
Rotary Speaker - Rate increase
Phaser - Rate increase
6