Install Filters - Best WC45 Manual Del Usuario

INSTALL FILTERS

DUCTED AND NON-DUCTED HOODS
NOTE: prior to use, remove protective film
from the filter frame.
1. To remove the GREASE filter, push in
latch tab to disengage the filter from the
hood. Tilt the filter downward and
remove (Fig.25).
2. To install the GREASE filter, align rear
filter tabs with slots in the hood. Push
latch tab in, push filter into position and
release. Make sure the filter is securely
engaged after installation.
NON-DUCTED HOODS ONLY
1. To remove the CHARCOAL filter, grip and
push filter tab toward rear of hood. Pull
the filter down to disengage the rear filter
tabs (Fig.26).
2. To install the CHARCOAL filter, align filter
in rectangular opening. Push filter against
springs in rear of hood and press into
place. Make sure the filter is securely
engaged after assembly.
3. Install GREASE filter after charcoal filter
is installed.
4. The charcoal filter replacement model is
AFCWC345.
- 17 -
FIG. 25
FIG. 26