Ω Ω Ω Ω Ω
400 Ω Ω Ω Ω Ω
399.9 Ω
Max reading
Digital
(1)
(3)
Accuracy
500 Ω
Max reading
Scale
Analogue
Reading
x10
coefficient
Accuracy
(2)
Permitted overload
(1) As % of the reading (rdg) from 10 to 100 % of the range (2) As % of the end of scale (3) 5%rdg ± 5 counts
8 - CONTINUITY SOUND TEST
Connection and specifications: idem Resistances for 400 Ω
range
Place the selector switch on the
Continuous audible beep emitted for a resistance R ≤ 400 Ω
9 - DIODE TEST
Connection and specifications: idem Resistances
Place the selector switch on the
Analogue reading: voltage drop up to 2000 mV for the forward
direction of the component.
50 scale, reading coefficient x 100
Digital reading: for the forward direction of the component, voltage
drop up to 2000 mV.
Accuracy: digital 2% rdg ± 2 counts and analogue 2.5% full scale.
NB: The positive polarity is on the V Ω Ω Ω Ω Ω Hz
10 - FREQUENCIES
Connect the leads to the multimeter and connect in parallel to
the circuit to be tested.
Set the switch to the Hz function
Digital reading: automatic range selection, kHz is displayed,
read the measured value.
If necessary, press the following keys,
HOLD to hold in memory
-
for display backlighting
-
No analogue reading: the needle stays on zero.
kHz
4 kHz
Maximum reading
3.999 kHz
Accuracy
Permitted overload
4 kΩ Ω Ω Ω Ω
40 kΩ Ω Ω Ω Ω
400 kΩ Ω Ω Ω Ω
4 MΩ Ω Ω Ω Ω
3.999 Ω
39.99 Ω
399.9 kΩ 3.999 MΩ 39.99 MΩ
1% rdg ± 2 counts
5 kΩ
50 kΩ
500 kΩ
5 MΩ
50
x0.1
x1
x10
x0.1
2.5%
600V
function
function
terminal
40 kHz
39.99 kHz
1% rdg ± 2 counts
1000 V
40 MΩ Ω Ω Ω Ω
(3)
50 MΩ
x1
400 kHz
399.9 kHz
21