Frequencies (Hz); Continuity And Resistance (W / ) - Chauvin Arnoux C.A 5240G Manual De Empleo

Plug the leads into the multimeter and connect in parallel to the
circuit to be tested.
Put the switch in the Hz voltage frequency position
Automatic measurement selection: read off the value measured
N.B.: the bargraph is inhibited when measuring frequency
If necessary, press on the following buttons:
- MIN-MAX to read min. and max. values
- To light up the display.
Hz
Resolution
Accuracy
Admissible
overload
Operating
range
(1) Trigger threshold:
- > 500 mV from 1 Hz to 100 kHz
- > 1.5 V from 100 kHz to 500 kHz
5 - CONTINUITY AND RESISTANCES
Never test a resistance on a live circuit.
Plug the leads into the multimeter and connect to the terminals
of the circuit or component to be tested.
Put the switch in the ohmmeter
Press on the
test to the measurement of resistance and vice versa.
Automatic measurement selection: read off the value measured
To save the measurement, if required, press on the HOLD button.
If necessary, press on the following buttons:
RANGE to select the measurement manually
MIN-MAX to read min. and max. values
To light up the display
16
4 - FREQUENCIES
100 Hz 1 kHz
0.01 Hz 0.1 Hz
± 10 ct
W / button to switch from the audible continuity
10 kHz
1 Hz
± 0.1 % reading
± 4 ct
500 V eff. and 750 V peak
at 500 V
(1)
W position
100 kHz 500 kHz
10 Hz 100 Hz
± 10 ct