jbc RP 5100 Manual Del Usuario página 7

ENGLISH
- Fit the new tip, and tighten up with the
spanner until the aluminium gasket is com-
pressed to achieve a good air tightness.
Tip care
- The largest rod that fits in the tip hole should
periodically be passed through in order to
clean the intake tube.
- To clean the tips, use the damp sponge
included with the stand.
- Do not file the tips or use abrasive tools
which may damage the tip's protective
surface coating and avoid knocking them
about.
- If the tip has been a long time without
being tinned, use the metal brush Ref.
0297705 adaptable to the support, to re-
move any dirt and oxid.
IMPORTANT: : : : : DO NOT use the vacuum pump
while tinning the desoldering tip, as the fumes
given off by the flux would quickly soil the ducts
and filter of the air circuit.
Emptying the desoldering
changing the filter
This should be done while the tip is still hot, with
a minimal temperature of 250°C, to make sure
the tin is melted, and therefore every precau-
tion should be taken.
- Release the clasp of the lock.
- Pull the lock then you take out the filter,
without spilling any of the solder in the tank.
- Empty the tank by tipping up the soldering
iron.
- Insert through the tip hole the rod which
matches its diameter.
- Note the state of the filter and replace it if
soiled or damaged.
- Put the lock with the filter again and make
the clasp secure.
Changing the pump inlet filter
- Disconnect the tube and unscrew the stopper.
- Take out the 3 paper filters, throw away
those which are soiled and replace them
with new ones. Always use 3 filters.
- Screw on the stopper and connect up the
tube.
- Check the airtightness.
tank and
Checking the suction circuit
To determinate if there is obstruction in the
suction circuit:
- Press the vacuum pump start button,
with the desoldering iron at a tempera-
ture of not less than 250°C to keep the
tin solder melted.
6