jbc RP 5100 Manual Del Usuario página 9

ENGLISH
Cancelling the access code
To carry out this operation, the control unit must
be opened and the following operations
performed:
- Solder a bridge between the point marked
PW and the relevant.
Bridge
- Close the control unit and connect the
apparatus. At this point the previous code
is annulled.
- Disconnect the apparatus, open the con-
trol unit, and desolder the bridge.
- You may now introduce a new access
code, after keying in the initial number
10000.
JBC reserves the right to change specifications mentioned in
this instructions manual without prior notice.
OFF
CAL
RST
PW
8