Electrical Connection - Eaton POTFOLIO IB520022EN Instrucciones De Instalación

Figure 6
Figure 7
Figure 8
Figure 9
Installation Instructions – LDSQ4B/LDSQ6B Commercial Recessed LED Rough-In www.eaton.com
Installation Instructions – LDSQ4B/LDSQ6B Commercial Recessed LED Rough-In
Cleaning
To Clean Trims:
1. Press in on white plastic latch to remove upper
reflector and clean lens. (Figure 10 & 11.)
2. Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
3. Wipe with mild detergent solution on a soft, clean
cloth to remove fingerprints and stains.
4. Rinse with clean water and dry with soft, clean, dry
lint-free cloth.
White
Plastic Latch
Figure 10
Figure 11

Electrical Connection

CAUTION
Make certain no bare wires are exposed outside of lever nut
connectors.
1. Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
junction box (located on the plasterframe). Supply wire
insulation must be rated for at least 90°C. The junction
box is rated for a maximum of 8 No. 12 AWG Branch
Circuit conductors and is also suitable for at least 90°C.
Upper Reflector
Lens
3