Fluke COMARK BT125 Manual Del Usuario página 6

Take care to either:
(a) Only place face up onto metal
surfaces.
(b) Ensure the App is not in recording
mode, or is stopped.
(c) Switch off the Pocketherm after each
use.
Maintenance
Cleaning
To maintain probe hygiene wipe regularly
with Comark probe wipe.
The instrument is waterproof and can be
washed under a running tap but is not to
be submerged.
Use only domestic kitchen cleaners or
mild detergents to clean this instrument.
Do not use aggressive cleaning
chemicals or solvents, these will attack
plastics and cause damage.
Battery Replacement
To replace the battery, fi rstly close the
probe then remove the battery cover
retaining screws on the rear of the
instrument using a Philips or fl at blade
screwdriver.* Remove the two cells
and dispose in local recycling facilities.
Replace with AA size alkaline cells only
carefully observing the correct polarity.
Visually check that the battery cover
and compartment are clean and free of
debris. Check that the seal in the battery
compartment is not displaced from the
locating groove before refi tting the cover.
Do not to over-tighten the screws when
refi tting the cover.
Should OTA appear on the display, simply
close and reopen the probe before use.
* Philips No 1 or 5mm fl at blade screwdriver.