Sanus VML5 Manual De Instrucciones página 8

4. Place the wall plate template
template and tape in place.
09
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5. Drill the four pilot holes using a 5.5 mm (7/32 in.) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 75 mm (3 in.).
4
8
at your desired height and position the slotted holes over your stud center lines. Level the wall plate
09
09
5
75 mm
(3 in.)
5.5 mm
(7/32 in.)
09