Cleaning Procedure - Stylies HYDRA Instrucciones De Uso

- after each use.
• Never use an extension cable that has been damaged.
• Never carry or pull the device by the power cable.
• Penetrating the housing with any kind of object is strictly prohibited.
• If the supply cord is damaged, it must be replaced by the manufacturer, an authorised repre-
sentative or a qualified person in order to avoid a hazard.
• Do not pull the power cable over sharp edges or allow it to become jammed.
• Never remove the plug from the socket by pulling at the power cable and never remove it with
wet hands.
• Do not use this humidifier in close proximity to a bath tub, shower or swimming pool (always
ensure a minimum distance of 3m). Always place the device in a position where it cannot be
reached by anyone in the bath tub.
• Do not set up the device near a source of heat. Do not subject the power cable to direct heat
(such as heat from hot oven hobs, naked flames, hot irons or heating furnaces). Keep the power
cable away from oil.
• Do not position the device directly next to walls, curtains or furniture.
• Ensure that the device is stable during operation and that no-one can trip over the power cable.
• The device is not splash-proof.
• Do not store or use the device outdoors.
• Store the device in a dry place, out of the reach of children (in its box).
• Do not add anything to the water (fragrances, essential oils or water fresheners).
Do not place the device directly on the floor. Use a water-proof underlay.
FIRST USE / OPERATION
Please note: never transport the device with a full water tank.
Possible hazards:
- there is too much water in the base of the housing and the spraying power is severely reduced.
- water can escape
- the water tank can fall and become damaged (and water can leak on to the floor).
1. For this reason, base (4) of the Stylies Hydra humidifier should initially be placed in a suit-
able location separately.
Important: Soak the anticalc cartridge in a water bath for 24 hours before the first use
(not in the water tank!). The resin has to absorb water to reach high performance.
2. When this base is in the desired location: Fill water tank (3) with water (hold the filling
opening slightly upright) – screw the lid back on firmly and check that it is water-tight.
Place water tank on base. Plug power cable (1) into the household power socket.
3. Switch on the Stylies Hydra humidifier using on/off switch (5) and select desired power
setting (7). The control display now appears blue. The steam outlet (2) can be turned 360°.
4. The desired air humidity can be selected using hygrostat regulator (6), from left (low hu-
midity) to right (high humidity). For example, if the regulator is turned completely to the left,
the device switches itself off at a relative humidity of approx. 30%, and only starts operat-
ing again when the humidity falls below the 30% mark. We recommend a medium setting
(in the comfort zone) for an optimal air humidity of around 40-60%.
Caution: the device will not switch on if the hygrostat has been set too low.

CLEANING PROCEDURE

Switch off the device and unplug the power cable from the socket before all maintenance work
•
and after each use.
9