After Operation With Detergent; Storing The Appliance; Frost Protection - Kärcher HDS 2.3/12 C Ed Manual Del Usuario

 With support of the detergent dose
valve set detergent concentration as
determined by the manufacturer.
Note: Recommended values at the control
panel at maximum working pressure.
Note: If detergent is be suctioned from an
external container, route the detergent suc-
tion hose through the recess to the outside.
 Set temperature and detergent concen-
tration according to the surface to be
cleaned.
Note: To prevent damage due to too much
pressure, always position high pressure ray
first from a greater distance towards object
to be cleaned.
Recommended cleaning method
Loosen the dirt:
–
 Spray detergent economically and let it
work for 1...5 minutes but do not let it
dry up.
Remove the dirt:
–
 Spray off loosened dirt with the high
pressure jet.
Operating with cold water
Removal of light contaminations and clear
rinse, i.e.: Gardening tools, terrace, tools,
etc.
The appliance works in the most economi-
cal temperature range (max. 140 °F/60 °C).
Operating with hot water
Danger
Scalding danger!
 Set device switch to desired tempera-
ture.
We recommend the following cleaning tem-
peratures:
Light contaminations
–
86 °F/30 °C-122 °F/50 °C
Contaminations containing protein, i.e.
–
in the food processing industry
max. 140 °F/60 °C
12
Cleaning
Eco level
Vehicle cleaning, machine cleaning
–
140 °F/60 °C-194 °F/90 °C

After operation with detergent

 Set dosing value for detergent to "0".
 Set the appliance switch to "1" (opera-
tion with cold water).
 Open the hand spray gun and rinse the
appliance for at least 1 minute.
Turn off the appliance
Danger
Danger of scalding by hot water. After oper-
ation with hot water, the device must be op-
erated with open end handgun with cold
water for at least two minutes.
 Set the appliance switch to "0/OFF".
 Shut off water supply.
 Open the hand spray gun.
 Turn on pump shortly (appr. 5 seconds)
with device switch.
 Pull main plug out of socket with dry
hands only.
 Remove water connection.
 Activate hand spray gun until device is
pressure less.
 Lock the trigger gun.

Storing the Appliance

 Lock in the steel pipe into the holder of
the appliance hood.
 Roll up high pressure hose and electri-
cal conduit and hang them into the re-
spective holders.
Note: Do not twist high pressure hose and
electrical conduit.

Frost protection

Caution
Frost will destroy the not completely water
drained device.
 Store in a frost free area.
If the device is connected to a chimney, the
following must be observed:
Caution
Threat of damage by penetrating cold air
through the chimney.
– 6
EN