Clearance; Clearing The Stainless Steel Surface - Gram FH Serie Manual De Utilización

Clearance

• Turn off the balance and unplug the data cables.
• Avoid the liquid into the balance.
• Any corrosive cleaner (solvent) is forbidden to use.
• Wipe the balance with a piece of soft cloth.
• Remove the weighing pan before wipe the balance.
• Remove the shield ring and pan support with the weighing pan which
helps avoid damage to the weighing system.

Clearing the stainless steel surface

All the stainless Steel components need to clean regularly. Remove the
weighing pan and thoroughl clean it with a damp cloth or sponge. The
cleaner applicable to stainless Steel are recommended. Wipe the stainless
Steel surface of the balance first and then clear the stainless Steel weighing
pan. Make sure there is no dirt and then wipe the stainless Steel component
again. Dry the balance by air. If necessary, smear the proper oil on the surface
as additional protection.
Note: After remove the weighing pan and the pan support, avoid any liquid or
solid pellet into the installation hole.
25