How To Load - EMAK TN4500 Uso Y Mantenimiento

How to park
cAutIon
o Choose a stable and flat surface
when parking the machine. If you
have to park downhill, make sure
you use some blocking bars on
the crawlers so that these do not
move.

5. How to load

cAutIon
o do not carry anybody as trans-
port inside the box and do not
drive while sitting or standing on
the machine.
How to open and close the extend-
ible sides of the box
the box can be opened for loading
and unloading as appropriate.
WArnInG
o Make sure you tighten the
tube's fixing screws once you've
opened or closed the board. It the
latter should fall over whilst the
machine is on the go, it could get
damaged or cause you personal
injury.
1. To slide the board inner wards or
outwards, first loosen screws from
tubes (A) which are positioned in
6 points: one on the right and one
on the left below the side boards,
two on the left and two on the right
below and behind the front boards.
2. Push the board towards the
wanted position.
3. Tighten the screws back on to the
tubes.
For models:
tn5600 - tn5600H
cr560 - cr560H
There is a version with extendible,
tipping sides .
To open and close the sides, fol-
low the same procedure for fixed
extendible sides .
See the illustrations below for tip-
ping the sides .
22