Adjusting The Clutch Lever; Nuts And Bolts That Have To Be Fixed On - EMAK TN4500 Uso Y Mantenimiento

9. Adjusting the clutch lever

• Check if the belt slips when the
clutch lever (A) is in the engaged
position.
• If the belt slips, adjust the adju-
sting screw (B) so that the distance
between the tension roller and the
belt is about 35-36 mm. (see illu-
stration).
Should the adjusting screw be in-
sufficient, adjust the motor support
ram.
10. nuts and bolts that have to be
fixed on
Engine assembly bolts (A)
Sprocket assembly bolts(B)
regularly check and tighten other
nuts and bolts.
31