EMAK TN4500 Uso Y Mantenimiento página 126

The side has 3 possible positions:
Vertical,
when pin A is in position 1.
Flat,
with pin A in position 2.
completely tipped,
with pin A in position 3.
To tip the sides, unscrew knob B,
lift the side and insert the pin in the
required position¬ (1-2-3).
Screw knob B back down.
How to use the box for transport
dAnGEr
o do not crawl below the trans-
port box when it is raised up.
WArnInG
o Always block the box with its
locking device otherwise it could
rise up when the machine is on
the go and fall over and cause the
machine to turnover.
23