Maintenance Schedule Table - Uline H-2957 Manual De Usuario

PART
Turntable Reducer
Film Carriage Reducer
Film Delivery Reducer
All Pivot Bearings
NOTE: Refer to electrical and mechanical component's operations manuals shipped inside the enclosure
for additional maintenance information.
WARNING! Make sure that only qualified
personnel will perform inspection,
troubleshooting, and part replacement.
HIGH VOLTAGE! Disconnect all power including
external control power that may be present
before servicing the frequency drive controllers.
WAIT for 3 (three) minutes for the DC bus
capacitors to discharge. The frequency drive
controller' display and/or LED's are not accurate
indicators of the absence of DC bus voltage.
OPERATING ISSUE
Machine not powering on.
Turntable is malfunctioning.
PAGE 15 OF 51

MAINTENANCE SCHEDULE TABLE

SCHEDULE
Sealed, lubricated with premium lubricant. No maintenance required.
Sealed, lubricated with premium lubricant. No maintenance required.
Sealed, lubricated with premium lubricant. No maintenance required.
N/A
TROUBLESHOOTING
CAUSES
The electrical control box is not closed.
The film carriage loading door is not closed.
The film carriage foot safety switch is not clear.
The system is not plugged into a 120VAC outlet.
Use a voltmeter to test supply voltage from the plant's
outlet. Is it reading 120VAC?
Use a voltmeter to test supply voltage from the plant's
outlet. Does it have continuity?
Turntable speed potentiometer dial not set high enough.
Resistance of potentiometer not equal to 5KΩ across.
Is the LED display on the turntable frequency drive?
The frequency drive is not functioning. Push the "STOP"
button. Wait 60 seconds, and then pull the button out. Is
the fault cleared?
The frequency drive is not connected properly to motor.
The parameters of the frequency drive are not set
correctly.
The turntable motor is not running.
None of the recommendations work.
This section will guide you in identifying typical problems
while operating the Predator Turntable Stretch Wrapper,
and provide you with corresponding solution(s). If further
assistance is required, call the number listed on the
last page of this manual. To receive quick and proper
technical support, please be prepared to provide the
following information:
1. Machine serial number
2. Date of purchase
3. Symptoms of any problem
RECOMMENDATIONS
Close the control box properly.
Close the carriage door properly.
Remove obstruction from the switch.
Plug machine into a 120VAC outlet.
Plug machine into a 120VAC outlet.
Replace the power cord to the machine.
Adjust potentiometer towards 100% to set speed.
Tighten wiring, replace dial if necessary.
Check and switch on main circuit breaker.
Refer to frequency drive manual for specific fault.
Tighten or replace wiring as necessary.
Restore drive parameters setting.
Check turntable motor for mechanical
restrictions.
Replace turntable frequency drive.
SERVICE WITH
N/A
N/A
N/A
N/A
0120 IH-2957