Charge The Battery; Connect The Sensor To The Meter - Hach FH950 Manual Básico Del Usuario

Figure 5 Install the battery

Charge the battery

Note: Battery charger substitution is not permitted. Use only the charger specified in the list of parts and
accessories for the instrument. Refer to Replacement parts and accessories in the expanded version of the manual.
Before initial use, fully charge the instrument battery with the supplied battery charger. A discharged
battery is fully charged in approximately 8 hours.
1. Make sure that the correct type of plug for the geographic location is installed on the battery
charger.
2. Connect the battery charger to an electrical outlet with earth ground.
3. Connect the battery charger to the battery charger connector on the instrument. Refer to
overview on page 8. The battery level shows on the display.
A blue light shows around the charge port while the battery charges. When the charge process is
complete, the blue light goes off.
Note: The meter is not operational while the battery charges. The battery does not charge through the USB
cable connection.

Connect the sensor to the meter

Meter
English 11