JVC VN-C215V4U Guía De Inicio página 21

1
ceiling slab
Towards the shooting
direction
Fall-prevention
wire
(not supplied)
4.
Connect the LAN cable. (A Pg. 26)
5.
Connect the power cable and the alarm
cable. (A Pg. 24)
Memo :
● The power cable must not be connected
when PoE is used.
6.
Wind the waterproof tape. (A Pg. 26)
4
Outer case
mounting screw
Less than 3 mm
Towards
2
fastening
hook
From the
3
T Loosen
sufficiently
5
Solder or crimp
Insulation tape
Wind the waterproof
6
tape.
Mounting
1.
Align the secured outer case with the
position alignment mark of the camera.
Note :
● Make sure that the cables are not caught in
the outer case.
2.
Turn the camera in the clockwise
direction.
T Check that the ○ mark can be seen. (Refer
to the diagram below)
3.
Tighten the Camera Fastening Screws
and secure the camera.
Position
alignment
mark
1
Image adjustment
When the camera is mounted, adjust the image
settings while looking at the actual image.
(A Pg.27 AImage adjustmentB)
Mounting the Dome Cover
After the image adjustment is completed, mount
the dome cover.
Installation is complete when the dome cover is
mounted.
(A Pg.29 AMounting the Dome CoverB)
2
T Check
Camera
Fastening
Screw
3
E-21