Lan Cable Connection; Alarm Input/Output Cable Connection - JVC VN-C215V4U Guía De Inicio

Setup

LAN Cable Connection

Connect the camera to a hub or computer using
a LAN cable.
When connecting to a hub
Make use of a straight cable.
When connecting to a computer
Make use of a Cross Over cable.
Note :
● Cross cables cannot be used with some
computer models. When connecting VN-
C215V4U directly to a computer, make sure
to check the computer's LAN specifications in
advance.
Memo :
● Make use of a Category 5 (or higher) cable in
the case of 100BASE-TX.
E-26
LAN cable
Alarm Input/Output Cable
Connection
Connect the alarm input/output cables with
external devices such as a sensor, buzzer, etc.
Signal name
Alarm input 1
Alarm input 2
Alarm output 1
Alarm output 2
GND
Cable to use
● Length of 50 m or shorter
● UL1007, UL1015 or equivalent products
● AWG#22 - AWG#18 or equivalent products
Wind the
waterproof
tape.
Note :
● Noises from an external source may cause
malfunctions even when the cable used is
shorter than 50 m. In this case, use a
shielded cable or move the cable away from
the noise source.
Cable color
Pink
Blue
Orange
Yellow
Brown
Alarm input/output cables
Solder or crimp
Insulation tape