Select Preset Equalizer; Adjust Eq Parameters; Adjust Fader/Balance - NORAUTO NS-412 BT MFI Manual De Uso

Select Preset Equalizer

1. Enter the EQ setup mode
Touch the [ ] icon in the user interface
and the EQ setup interface will display on
the screen.
2. Select EQ mode
∙ [User] ∙ [Rock]
∙ [Flat] ∙ [Class]
∙ [Pop] ∙ [Jazz]
∙ [Techno] ∙ [Optimal]

Adjust EQ Parameters

To adjust EQ parameters, touch and drag the
parameters adjustment bar.
Touch [ ] / [ ] or drag [
parameters.
[ User ]: Set the desired audio effect.
∙ [BAS] bass range: -7 to 7
∙ [MID] middle range: -7 to 7
∙ [TRE] treble range: -7 to 7
∙ [LPH] low pass filter range: 60HZ, 80HZ,
100HZ, 200HZ
∙ [MPF] middle pass filter range: 0.5KHZ,
1.0KHZ, 1.5KHZ, 2.5KHZ
∙ [HPF] high pass filter rang: 10.0KHZ,
12.5KHZ, 15KHZ, 17.5KHZ
[ LOUD: On/Off ]: When listening to music
at low volumes, this featurewill selectively
boost certain bass and treble frequencies.
[ RESET ]: Cancel the equalizer function
settings.
Basic Operations

Adjust Fader/Balance

You can adjust front/back/left/right balance
of the speaker and the subwoofer volume to
get balanced listening effect according to the
surroundings and your interest.
1. Enter the EQ setup mode
Touch the [
and the EQ setup interface will display on
the screen.
2. Adjust subwoofer volume
Touch [
subwoofer volume from 0 to 38.
3. Adjust fader / balance value
] to adjust the
Touch [
fader / balance value
∙ [
∙ [
∙ [
∙ [
1. The parameters of the EQ modes has
been preset and you can not change them
besides 'User'.
2. The EQ mode will change to 'User'
automatically when you adjust the
frequency value under the modes besides
'User'.
3. The value of Sub is independent of EQ
mode and can be adjusted separately.
156
] icon in the user interface
] / [ ] or drag [
] / [ ] / [ ] / [
]: Front speaker, fader range: 0 to 7.
]: Rear speaker, fader range: 0 to 7.
]: Left speaker, balance range: 0 to 7.
]: Right speaker, balance range: 0 to 7.
Note:
] to adjust
] to adjust