Select Preset Equalizer; Adjust Eq Parameters; Adjust Fader/Balance - NORAUTO NS-411 BT Manual De Uso

Select Preset Equalizer

1. Enter the EQ setup mode
Touch the [ ] icon in the user interface and the EQ setup
interface will display on the screen.
2. Select EQ mode
∙ [User] [Flat
∙ [POP] [Techno]
∙ [Rock] [Class]
∙ [Jazz] ∙ [Optimal]

Adjust EQ Parameters

To adjust EQ parameters, touch and drag the parameters
adjustment bar.
Touch [ ] / [ ] or drag [
[ User ]: Set the desired audio effect.
∙ [BAS] bass range: -7 to +7
∙ [MID] middle range: -7 to +7
∙ [TRE] treble range: -7 to +7
∙ [LPH] low pass filter range: 60HZ, 80HZ, 100HZ, 200HZ
∙ [MPF] middle pass filter range: 0.5KHZ, 1KHZ, 1.5KHZ,
∙ [HPF] high pass filter rang: 10KHZ, 12.5KHZ, 15KHZ, 17.5KHZ
[ LOUD: On/Off ]: When listening to music at low volumes, this
featurewill selectively boost certain bass and
treble frequencies.
[ RESET ]: Cancel the equalizer function settings.

Adjust Fader/Balance

You can adjust front/back/left/right balance of the speaker and the
subwoofer volume to get larruping listening effect according to the
surroundings and your interest.
1. Enter the EQ setup mode
Touch the [ ] icon in the user interface and the EQ setup
interface will display on the screen.
2. Adjust subwoofer volume
Touch [ ] / [ ] or drag [
from 0 to 38.
3. Adjust fader / balance value
Touch [ ] / [ ] / [
]: Front speaker, fader range: 7 to 7.
∙ [
]: Rear speaker, fader range: 7 to 7.
∙ [
]: Left speaker, balance range: 7 to 7.
∙ [
]: Right speaker, balance range: 7 to 7.
∙ [
Notes:
1. The parameters of the EQ modes has been preset and you can
not change them besides 'User'.
3. The EQ mode will change to 'User' automatically when you
adjust the frequency value under the modes besides 'User'.
4. The value of Sub is independent of EQ mode and can be
adjusted solely.
Basic Operations
] to adjust the parameters.
2.5KHZ
] to adjust subwoofer volume
] / [ ] to adjust fader / balance value
62