Setting The Temperature; Switching Off The Cooler; Storing The Cooler - Waeco CoolFreeze CF-32UP Instrucciones De Uso

CF-32UP.book Seite 41 Donnerstag, 16. Juli 2009 5:21 17
7.5

Setting the temperature

➤ Press the "SET" button (fig. 3 4, page 3) once.
✓ The cooling temperature is shown.
Note
I
If no temperature is displayed, but only "LO", press the "SET" but-
ton until the cooling temperature appears.
➤ Use the "UP +" (fig. 3 6, page 3) and "DOWN –" (fig. 3 7,
page 3) buttons to select the cooling temperature.
✓ The set cooling temperature then appears in the display for a
few seconds. The display flashes several times before it returns
to the current temperature.
7.6

Switching off the cooler

➤ Empty the cooler.
➤ Switch the cooler off by pressing the "ON/OFF" pushbutton
(fig. 3 1, page 3) for approximately 2 seconds until the
temperature display switches off.
➤ Set the battery switch (fig. 4 2, page 4) to "BATTERY OFF".
➤ Detach the connection cable.
7.7

Storing the cooler

If you will not use the cooler for a longer period of time:
➤ Fully charge the internal battery.
➤ Set the battery switch (fig. 4 2, page 4) to "BATTERY OFF".
In doing so, you prevent the internal battery from fully discharging
despite the cooler being switched off. Completely discharging the
internal battery will destroy it.
Caution – danger of damaging the device
a
Fully charge the internal battery at least every six months.
Using the cooler
41