Defrosting The Cooler; Replacing The Plug Fuse (12/24 V); Changing The Internal Battery - Waeco CoolFreeze CF-32UP Instrucciones De Uso

CF-32UP.book Seite 42 Donnerstag, 16. Juli 2009 5:21 17
Using the cooler
7.8

Defrosting the cooler

Humidity can form frost in the interior of the cooler or on the
evaporator. This reduces the cooling capacity. Defrost the
device in good time to avoid this.
Caution – danger of damaging the device
a
Never use hard or sharp tools to remove ice or to free objects fro-
zen on the device.
To defrost the cooler, proceed as follows:
➤ Empty the cooler of its contents.
➤ If necessary, put them in another cooling device to keep
them chilled.
➤ Switch off the device.
➤ Leave the lid open.
➤ Wipe off the condensate.
7.9

Replacing the plug fuse (12/24 V)

➤ Pull the adapter sleeve (fig. 7 4, page 4) off of the plug.
➤ Unscrew the screw (fig. 7 5, page 4) out of the upper half of
the housing (fig. 7 1, page 4).
➤ Carefully lift the upper half of the housing off the lower half
(fig. 7 6, page 4).
➤ Take out the contact pin (fig. 7 3, page 4).
➤ Replace the defective fuse (fig. 7 2, page 4) with a new one
that has the same rating (8 A 32 V).
➤ Re-assemble the plug in the reverse sequence of steps.
7.10

Changing the internal battery

Note
I
WAECO recommends having the battery replaced by an expert.
You can find instructions for replacing the battery on the product
page for the device at: www.waeco.com.
If the internal battery needs to be exchanged, please contact the
WAECO hotline (see addresses on the back page).
42