OHAUS TAJ602 Manual De Instrucciones página 5

USB Interface
BALANCE SETUP
A) The Ohaus Interface is preset to communicate using the following settings: 2400 baud, 7 bit,
no parity, no handshake. If different settings are desired, it will be necessary to change either
the balance settings, or the computer settings.
B) Upon installation of the interface, the balance will recognize the USB Interface and add
relevant items to the menu. Configure the balance to the desired USB and printing
parameters; refer to the balance User Manual for assistance in using the menus.
PRINT
Stable
On, Off
A-Print
Cont, On.Stbl, On.Acc*, 5sec, 15sec,
30sec, 60sec, off
End
Yes, No
*Note: Print and USB menu
selections may vary between
the different balance series.
SETUP DEFINITIONS
PRINT / Stable - On
PRINT / Auto Print – Continuous
PRINT / Auto Print – On Stable
PRINT / Auto Print – (xx) sec
PRINT / Auto Print – Off
USB / USB –Off
USB / Baud, Parity, Handshake
OPERATION
USB OUTPUT
With the Adapter installed the balance will operate in one of the following three ways:
•
USB = on, Auto Print = off, Stable = on or off
Pressing PRINT will send the display data based on the settings in the Menu.
If Stable is set to On, the balance will wait for a stable reading before sending data.
•
USB = on, Auto Print = on, Stable = on or off
The balance will automatically send data.
If Stable is set to On, only stable values will be sent.
•
USB = off
The interface is turned off. During battery operation, this saves significant power.
USB
USB
On / off
Baud
600, 1200, 2400, 4800, 9600, 19200
Parity
7-even, 7-odd, 7-none, 8-none
Handshake
None, Xon-Xoff, RTS-CTS
END
Yes, No
Balance transmits stable data only.
Balance repeatedly sends data as fast as possible.
Balance automatically outputs data upon stability.
Balance sends data every (xx) seconds.
Only sends data when PRINT is pressed.
Turns Interface off, saving battery power.
Set parameters to match printer or computer.
EN-3