OHAUS TAJ602 Manual De Instrucciones página 7

USB Interface
1S print stable data only
Navigator Commands
P same as pressing Print
SP print stable weight only
IP immediate print of displayed weight (stable or unstable)
CP Continuous print of weights
SLP Auto-print stable non-zero weight only
SLZP Auto-print stable non-zero weight and zero reading
xP Auto-print on 1 to 3600 second intervals (x = 1 to 3600)
0P turns auto-print off
PM print current mode
M advance to the next enabled mode
PU print current unit
U advance to the next enabled unit
T same as pressing Tare
Z same as pressing Zero
PV print software version
AUTO-PRINT OPERATION
Once Auto-Print is activated in the menu, the balance will send data as required. To temporarily stop
Auto-Printing, press the PRINT key. If there is data in the print buffer the printer will finish printing
this data. A second press will resume Auto-Printing.
ACCESSORIES
For a complete listing of Ohaus printers and other accessories, contact Ohaus Corporation or visit
www.Ohaus.com
COMPLIANCE
This accessory has been tested and complies with the approvals listed in the applicable Instruction
Manual.
In conformance with the European Directive 2002/96 EC on Waste Electrical and
Disposal
Electronic Equipment (WEEE) this device may not be disposed of in domestic waste.
This also applies to countries outside the EU, per their specific requirements.
Please dispose of this product in accordance with local regulations at the collecting
point specified for electrical and electronic equipment. If you have any questions,
please contact the responsible authority or the distributor from which you purchased
this device.
Should this device be passed on to other parties (for private or professional use), the
content of this regulation must also be related.
For disposal instructions in Europe, refer to www.ohaus.com/weee.
Thank you for your contribution to environmental protection.
EN-5