Reviewing Batch Data - Ptg8 - Elcometer NDT PTG6 Guia Del Usuario

10 BATCHING - PTG8 (continued)
The grid / table is a template of the
measurement area and where each
reading is to be taken. If for any reason a
reading cannot be taken in a particular
location, due to a steel girder for example,
the 'Obst' softkey can be used. When the
transducer is removed from the surface,
the 'Save' softkey changes to 'Obst'.
Pressing 'Obst' records that a reading
could not be taken.
Note: The number of readings within the batch includes those recorded as 'Obst'
however, 'Obst' readings are not included in statistics calculations.

11 REVIEWING BATCH DATA - PTG8

11.1 BATCH STATISTICS (Batch/Review Batch/Statistics)
Displays statistical information for the batch including:
Number of readings in the batch (n:)

Average reading for the batch (

Lowest reading in the batch (Lo:)

Highest reading in the batch (Hi:)

Nominal value (x:)

Range (

between the highest and lowest
reading in the batch
Standard Deviation (σ:)

Low limit value (

below the low limit (
High limit value (

above the high limit (
en-23
R
); the difference
) - if set - and the number of readings
)
) - if set - and the number of readings
)
:)
X
www.elcometer.com