Transcend Auto Manual Del Usario página 5

Setting up the LCD Programming Base Station
• Begin by connecting a Somnetics-
approved power source into the LCD
(Fig 1.) If using the AC power supply,
plug it into the wall outlet.
• Place the PAP into the LCD (Fig 2.) by
first sliding the front hooks of the PAP
into the front slats of the LCD then
press down on the back of the PAP
until it snaps into place on the LCD.
• Connect the LCD to the PAP (Fig 3.) by
using the USB cable and PAP power
cable located at the back of the LCD.
USB Cable
Fig. 3.
LCD PROGRAMMING BASE STATION PATIENT MANUAL
USB Cable
Fig. 1
• ENGLISH • PAGE 5
AC Power
Supply
PAP
Power
Supply
Fig. 2
PAP
Power
Cable
AC Power
Supply