Patient Mode - Transcend Auto Manual Del Usario

Section 1: Operation

Patient Mode

1. The LCD must be connected to a power supply (e.g. AC power supply, Mobile
Power Adaptor, or P4 or P8 Battery) for correct information to display and to
change PAP ramp settings (see below). Follow the directions in 'Setting up the
LCD Programming Base Station' section prior to operation.
2. To review therapy data, push the "→" button to cycle through the following
screens in the order presented below. The " " or "↓" buttons do not change the
display except as noted.
• To turn on the LCD press any button.
• To turn off the LCD, disconnect the power supply from the LCD. Remove the USB
cable and PAP power cable from the PAP device.
Note: This device does not have a back button. If a screen is passed, the user
must advance through the screens using the "→" button to return to the desired
screen.
Note: Use the device in adequate lighting conditions in order to view the screens
below.
Auto EZEX Transcend
X
X
X
X X
LCD PROGRAMMING BASE STATION PATIENT MANUAL
Screen Display Description
Minimum Pressure
(4-20 cm H 2 O)
1 = min pressure; digits to the
right display value
Starting Pressure
(min pressure - 20)
2 = max pressure; digits to the
right display value
Starting Pressure (between min
and max pressure)
3 = starting pressure; digits to the
right display value
Therapy Pressure
(4 – 20 cm H 2 O)
• ENGLISH • PAGE 6