Transporting The Compressor; Installing The Power Cord - Invacare HomeFill II IOH200AW Manual Del Usuario

Invacare® HomeFill® II Oxygen System

3.4 Transporting the Compressor

WARNING!
– NEVER transport a compressor with a cylinder
connected to or stored on the compressor,
otherwise injury or damage can occur.
CAUTION!
– When transporting the compressor, be careful
not to bump the compressor or the connectors
into obstacles. Otherwise, damage to the
compressor may occur.
1. There are two methods to safely transport the
compressor:
• One Hand - Grasp the hand grip A at the bottom
rear of the compressor.
• Two Hands - Grasp the hand grips B on the sides
of compressor.
16

3.5 Installing the Power Cord

1. Choose a proper location. Refer to Choosing a Location
in this section of the manual.
2. Make sure the power switch is in the Off (O) position.
3. Plug the power cord into the electric connector A in
the back of the compressor B.
4. Plug the opposite end of the power cord C into the
wall outlet D.
5. Leave a minimum of 3 in (7.6 cm) clearance to the
power cord ends for disconnection access.
The power inlet acts as the mains disconnection
device to remove all power to the unit when the
line cord is disconnected.
1195663-C