Connections; Hydraulic Connections - Carrier 50CO Manual Del Usaurio

W115 Under Assembly
Electric heater
(option)
Access
hatches

10 - CONNECTIONS

When following these steps, please consult the dimensional drawing and connection diagram as well as the wiring diagram found
inside the unit.

10.1 Hydraulic connections

The hydraulic pipes must be routed through the plates provided for this purpose in the unit frame. This is either done to the right
of the unit or directly underneath.
These plates must be drilled (water circuit + condensate draining) then refitted in place before the hydraulic pipes are routed
through them.
For the W115 model, the pipes on the right are routed through a fixed insulated panel.
please see the dimensional drawing and connection diagram to locate the routing areas and connection positions.
Filters
FMA
EN - 7
Electrics Box
Cooling coil
Control valve
side plate
Foam
panel
EN
X0039,03.2015