Bases - Carrier 50CO Manual Del Usaurio

11.2.5 Bases:

• Support base:
Adjustable feet
For supply air through a raised floor.
The height can be adjusted from 250 mm to a maximum of 610 mm. Adjustment screws are provided with the base for adjustment
on site. Do not forget to stick the adhesive seal provided to the aluminium frame of the base to ensure tightness.
• Cased base with grid:
Double-deflection grids
Adjustable feet
Can be used either for intake or for supply air.
The height can be adjusted from 450 mm to a maximum of 860 mm. Adjustment screws are provided for adjustment on site.
Do not forget to stick the adhesive seal provided to the aluminium frame of the base to ensure its tightness.
Made up of double-deflection grids to direct the air flow.
Side hatch for pipe connection (hydraulic or refrigerant connection) + grommet for power supply cable.
• Cased base with damper:
Adjustable feet
This is mainly used to insulate the unit when it is connected to a duct system.
The damper prevents air returning to the unit when it is not operating and when other units are operating nearby.
The height can be adjusted from 630 mm to a maximum of 860 mm. Adjustment screws are provided for adjustment on site.
Do not forget to stick the adhesive seal provided to the aluminium frame of the base to ensure its tightness.
Damper
Access hatch for servomotor damper
EN - 17
Grommet for power supply
cable connection
Plate for hydraulic connection
Grommet for power supply
cable connection
Plate for hydraulic connection
X0039,03.2015
EN