Maintenance And Care; Gear Housing - Flex L 15-10 150 Instrucciones De Funcionamiento

466.387_L15-10 150_L21-8 180_L26-6 230.book Seite 15 Montag, 19. März 2018 2:35 14
L 15-10 150 / L 21-8 180 / L 26-6 230

Maintenance and care

WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always
disconnect the tool from the power supply.
Cleaning
WARNING
Risk of electric shock! If metals are ground
or cut over a prolonged period, conductive
dust may become deposited inside the
housing. Impairment of the protective
insulation!
Operate the power tool via a residual-
current-operated circuit-breaker (tripping
current 30 mA).
Regularly clean the power tool and venti-
lation slots. Frequency of cleaning is depen-
dent on the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
CAUTION
Risk of injury! Wear safety glases while
using compressed air.
All plastic parts should be cleaned with soft
damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve
or otherwise damage the material.

Gear housing

The gear housing should never be loosened
or opened, except by a FLEX authorized
service center. Doing so will void the
product warranty.
Brush inspection and lubrication
For your continued safety and electrical
protection, brush inspection and
replacement on this tool should ONLY be
performed by an authorized service center
for FLEX Power Tools.
At approximately 100 hours of use, take or
send your tool to your nearest authorized
service center for FLEX Power Tools to be
thoroughly cleaned and inspected; worn
parts replaced; and when necessary,
relubricated with fresh lubricant if required;
reassembled with new brushes; and
performance tested.
Any loss of power before the above
maintenance check may indicate the need
for immediate servicing of your tool. DO
NOT CONTINUE TO OPERATE TOOL
UNDER THIS CONDITION. lf proper
operating voltage is present, return your tool
to a FLEX authorized service center for
immediate service.
Repairs
All quality tools will eventually require
servicing or replacement of parts due to
wear from normal use. These operations,
including brush inspection and replacement,
should ONLY be performed by an
authorized service center for FLEX Power
Tools. All repairs made by these agencies
are fully guaranteed against defective
material and workmanship.
We cannot guarantee repairs made or
attempted by anyone other than these
agencies.
Should you have any questions about your
tool, feel free to write us at any time. In any
communications, please give all information
shown on the nameplate of your tool (model
number, type, serial number, etc.).
Spare parts and accessories
For further accessories, in particular
grinding tools, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists
can be found on our homepage:
www.flex-tools.com
Instruction manual
15