ABB TB82PH Serie Instrucciones De Operación página 16

TB82PH ATEX Product Instruction Manual
7.00
PH.GLAS
exit to
MEASURE
ENTER
Figure 19
0.05
SECS
exit to
MEASURE
ENTER
Figure 21
7.00
SAFE.MD
exit to
MEASURE
FAULT ENTER
info
Figure 23
7.00
Save?
exit to
MEASURE
Figure 25
16
MEASURE
CALIBRATE
pH
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
NEXT
MEASURE
CALIBRATE
oH
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
MEASURE
CALIBRATE
pH
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
NEXT
MEASURE
CALIBRATE
pH
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
YES NO
0.00
pH
4MA.PT
exit to
MEASURE
ENTER
Figure 20
OFF
pH
DIAGS
exit to
MEASURE
ENTER
Figure 22
7.00
pH
Fail.lo
exit to
MEASURE
FAULT ENTER NEXT
info
Figure 24
Caution.
If a programming change has been made,
pressing the Exit to MEASURE key will activate
the SAVE? display (Figure 25). YES and NO
keys will also appear. Press the YES key to save
the changes. If the NO key is pressed any
configuration or programming changes will not be
saved.
Note.
Diagnostics is a function valid only with a TBX5
Advantage pH sensors or an AP200 with a
solution ground rod that is connected to Terminal
TB2-4 (green, SOL GND). Diagnostics must be
turned 'OFF' if TB5, AP100, AP300, 7650/7660,
ORP or sensors without an integral solution
ground are used.
ABB
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
TB82PH-ATEX-EN-B