Inserting/Replacing The Chisel; Operation; Maintenance And Cleaning - Parkside PDMH 4500 B5 Traducción Del Manual De Instrucciones Original

Inserting/replacing the chisel

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply before
changing tools.
♦ Insert the desired chisel 5 into the tool
holder 4 of the chisel hammer .
♦ Then slide the tension spring 6 over the
chisel 5 .
♦ Screw the tension spring 6 onto the thread 1
until it stops . When doing so, hold the tension
spring 6 by the front retaining clip .
♦ To change the chisel 5, unscrew the tension
spring 6 from the cylinder of the chisel
hammer by holding it by the rear clip .
Chisel types
There are three different types of chisels 5 supplied
for different purposes:
- Flat chisel: Use this chisel, for example, to remove
protruding concrete or mortar residue .
- Separating chisel (sheet metal chisel): Use this
chisel, for example, to cut sheet metal .
- Pointed chisel: Use this chisel, for example,
to break open, break through and break off
masonry and stone .

Operation

♦ Align the appliance with the area to be machined .
♦ Press the trigger 3 to switch the appliance on .
♦ Release the trigger 3 to turn off the appliance .
♦ When you have finished working, disconnect
the appliance from the compressed air source .
■ 32 │ GB │ MT

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may (due to working process-
es) have accumulated on the appliance . Avoid
all skin contact with these substances . If the
skin comes into contact with hazardous dusts,
this can lead to severe dermatitis .
► The dust and vapours produced by using the
appliance can be hazardous to health (e .g .
cause cancer, birth defects, asthma and/or
dermatitis); it is essential to carry out a risk as-
sessment in respect of these risks and to imple-
ment corresponding regulatory mechanisms .
NOTE
► The following points must be observed to en-
sure that the compressed air tool functions cor-
rectly and has a long service life:
■ Before each use, check the tool and the insert
tool, including a check of the speed and vibra-
tion level .
■ After each use, check the speed and vibration
level of the tool . During maintenance work,
please ensure that appropriate protective cloth-
ing (ear muffs, dust mask, protective goggles
and protective gloves) is worn .
■ Sufficient and continuous oil lubrication is highly
important for optimum functioning .
■ Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at danger . In doubt, contact the
Service Centre .
■ Use only accessories and supplies of the sizes
and types recommended by the manufacturer .
■ Only clean the appliance with a soft, dry cloth
or with compressed air .
■ Never use sharp or abrasive cleaning agents
under any circumstances .
PDMH 4500 B5