Cannondale FORESITE HS Instrucciones

Stem
Headset
Spacer Light
YOUR CANNONDALE RETAILER
Along with this manual, your key source of information and assistance is the shop where you
purchased this product. Your local Authorized Cannondale Retailer is your primary contact
to discuss service and adjustment to this product, instruction in its use, and any warranty
questions. To find authorized Cannondale Dealer closest to you, use the appropriate contact
information listed below.
Product Codes:
C4FLHS30BK - HDSET SPACER LIGHT 30MM BLACK
C4FLHS30WT - HDSET SPACER LIGHT 30MM WHT-BLK
C4FLHS30BZ - HDSET SPACER LIGHT 30MM BEZERKER
Installation:
This headset spacer light must be installed by a professional bicycle mechanic . See WARNINGS.
To operate the light:
Initially, before operating the light, you must remove the battery tab located under the batteries.
To do it, simply lift up the rubber covering and pull the small plastic tab under the battery out.
Replace the cover over the batteries.
The switch that turns the light on and off is located on the front of the spacer in the area
indicated above. Pressing down on the covering activates the switch.
Turn the light off, when you are not using it, to preserve battery energy.
To change batteries:
When the light unit dims or fails to light properly, replace the two batteries with new ones. The
batteries can be replaced without removing the light.
1. Lift the flexible cover up and slide out the two batteries from the holder. Do not pry the
batteries; you will damage the holder.
2. Stack together two new CR2032 type batteries into the holder. The positive side of each
batteries must face the "+" marking on the holder as shown.
3. Replace the cover and make sure it is fitted properly around the spacer body.
CANNONDALE AMERICAS CANNONDALE EUROPE
Cycling Sports Group, Inc. Cycling Sports Group Europe, B.V.
172 Friendship Village Road, mail: Postbus 5100
Bedford, Pennsylvania, visits: Hanzepoort 27
15522-6600, USA 7570 GC, Oldenzaal, Netherlands
(Voice): 1-800-BIKE-USA (Voice): +41 61.4879380
(Fax): 814-623-6173 (Fax): 31-5415-14240
custserv@cyclingsportsgroup.com servicedeskeurope@
cyclingsportsgroup.com
1 1/8" Fork Steerer
Headset
HeadTube
Fork
Front view
CANNONDALE UK
Cycling Sports Group
Vantage Way, The Fulcrum,
Poole, Dorset, BH12 4NU
(Voice): +44 (0)1202 732288
(Fax): +44 (0)1202 723366
sales@cyclingsportsgroup.co.uk
FORESITE HS
Headset Spacer Light Instructions - 05/13
LEDs
Light Emitting Diodes
Operating Times:
Flashing mode: 100 hours
Steady mode: 75 hours
(approximate)
Operation Modes:
OFF FLASHING STEADY
Press here to operate
(switch is located under the cover)
Only when you are stopped!
WARNINGS
INTENDED USE: Intended to be used as the first spacer above the headset on 1 1/8" compatible
headset systems. This light is intended to be used as a dusk or daytime running light. It
is intended to draw attention to you while riding and increase the chance of other cyclists,
pedestrians and motorists seeing your bike approaching. Because the light is a lower intensity,
it is NOT a replacement/substitute for higher intensity lights such as those that mount to a
handlebar or helmet.
COMPATABILITY & INSTALLATION: For your safety, the headset spacer light must be installed
by a professional bike mechanic experienced with headset installations. The illustration above
is simplified. Installation on your bike may require changes to headset/stem/compression
assembly components for safe compatability. Do not attempt to install the light yourself!!
WHILE RIDING: Come to a stop before changing the operating mode. Press the power switch
only when your bike is stopped. If you don't you can lose control of the bike and have an
accident.
HIGHER RISKS RIDING AT NIGHT: The risk of an accident, particularly being struck by a motor
vehicle, is much higher at night. If you choose to accept this risk, improve your odds with a
proper lighting system, strobe light, light colored reflective clothing and careful riding. Seek the
advice of an experienced bicycle commuter at your retailer.
ANY LIGHTING SYSTEM CAN FAIL WITHOUT WARNING. Ride cautiously, with a good margin for
error. Many experienced cyclists use two lighting systems, one helmet mounted, one mounted
on the bicycle.
DO NOT REMOVE LOCALLY REQUIRED REFLECTOR SYSTEM FROM YOUR BIKE.
YOU CAN BE SEVERELY INJURED, PARALYZED OR KILLED IN AN ACCIDENT IF YOU IGNORE THESE
WARNINGS.
NOTICE
- This product is rain-proof only. Do not submerge or power wash.
- Turn unit OFF after use.
CANNONDALE JAPAN CANNONDALE AUSTRALIA
Namba Sumiso Building 9F, Cycling Sports Group
4-19, Minami Horie 1-chome, Unit 8, 31-41 Bridge Road
Nishi-ku, Osaka 550-0015, Japan Stanmore NSW 2048
(Voice): 06-6110-9390 (Voice) +61 (0)2 8595 4444
(Fax): 06-6110-9361 (Fax): +61 (0) 8595 4499
cjcustserv@cannondale.com askus@cyclingsportsgroup.com.au
Side view
35
30
47
28.8
(all dimensions in mm)
Batteries located under cover here
Rear view
Replacement Batteries
Qty 2 - CR2032
(DO NOT REMOVE FROM BIKE
TO CHANGE BATTERIES)
CANNONDALE CHINA
Cycling Sports Group China Co., Ltd.
Room 208, No. 3203, Minghang
District Hongmei Road, Shanghai
201103, China
(Voice): 86 21 6446 8999
(Fax): 86 21 6465 6570
csg@dorelchina.com
130281 Headset Spacer Light Instructions - 0513