Connecting/Positioning The Nasal Cannula - Invacare XPO2 Manual De Usuario

SECTION 6—OPERATING INSTRUCTIONS
Connecting/Positioning the Nasal
Cannula
To ensure proper breath detection and oxygen delivery, DO
NOT use tubing length exceeding 25 ft (7.6 m).
NOTE: For this procedure, refer to FIGURE 6.8.
NOTE: Invacare recommends using the XPO
cannula. The tubing must be connected to the XPO
as shown below.
NOTE: Replace the nasal cannula on a regular basis. Check with
your equipment provider or physician to determine how often the
cannula should be replaced.
NOTE: DO NOT share cannulas between patients.
1. Connect the nasal cannula to the XPO
(Detail "A").
2. Place the cannula over your ears and position the prongs
in your nose as instructed by your health care provider or
cannula manufacturer (Detail "B").
Invacare® XPO ™
2
CAUTION
30
with a 4 ft (1.2 m)
2
oxygen outlet
2
oxygen outlet port
2
Part No 1160887