Polaris TR28P Manual Del Propietário página 10

Fine Tuning the Cleaner
When operating correctly, the Polaris
throughout the pool. The climbing ability depends on the pool's shape and water pressure or flow.
The cleaner climbs best in pools without sharp angles or curves in the transition from the pool floor
to the pool wall. Approximately every 3-1/2 minutes the cleaner goes into back-up mode. This action
pulls the cleaner away from pool obstacles and increases its random pattern.
Fine tune your cleaner for optimal operation, as necessary.
1
Adjust the Sweep Hose
The Sweep Hose (d) should move in a gentle sweeping motion. To increase
or decrease sweeping motion:
1. Turn the booster pump OFF.
2. Rotate the sweep hose screw on the Feed Pipe (f).
2
Adjust the Thrust Jet
If the cleaner is veering left or right instead of tracking straight, adjust the
thrust jet (on the back of the cleaner) for climbing or turning.
NOTE: Factory default setting is straight back. Only adjust the thrust jet to
accomodate unique pool shapes.
10
cleaner vacuums, sweeps and scrubs all surfaces randomly
®
Decrease
motion
Turning
Increase
motion
Climbing