Polaris TR28P Manual Del Propietário página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Feed hose becomes tangled.
Sweep hose is sucked into
the vacuum tube.
Sweep hose sprays too much water
The cleaner does not clean the
The cleaner is running in circles on
Solution
1. Remeasure the hose to verify that it is adjusted to the
proper length for the pool shape.
2. With the cleaner operating, check that the swivels in
the hose and the hose connections turn freely.
3. Make sure feed hose is floating.
4. With the cleaner turned off, spin each of the wheels.
All wheels should turn together.
1. Make sure the opening at the end of the sweep hose is
not blocked by the sweep hose scrubber.
2. Adjust the sweep hose to a gentle sweeping motion.
1. Verify the TailSweep PRO
out of the pool.
2. Adjust the speed of the sweep hose by tightening the
adjustment screw.
3. Replace the sweep hose scrubber if it is worn or
missing.
4. Add a sweep hose weight (part #B2) available through
a Polaris
1. Check the hose length reaches within 6" of the farthest
entire pool.
point of the pool. If not, order a new hose section from
your
Polaris dealer.
2. Check thrust jet for straight back position that optimizes
random turning.
3. While the cleaner is operating, hold it upside down
and look into the vacuum tube. There should be two
distinct, even jets of water. If there are not, contact
Customer Service or a Polaris dealer for assistance.
1. Check filter bag, if full it can weigh the cleaner down on
its side.
one side.
2. Remove the head float and shake it. If there is water in
the float, order a new one.
3. Check the hose floats to ensure they are spaced
evenly.
is installed correctly.
®
dealer.
®
13

Publicidad

Tabla de contenido
loading

Tabla de contenido