Routine Maintenance - Polaris TR28P Manual Del Propietário

Routine Maintenance

Perform routine maintenance to prolong the life of your cleaner.
1
Empty the Bag
Empty the bag when it is half full, especially if the debris load is sand.
NOTE: It is easier to empty the bag when it is dry. Alternate between two bags.
1. Remove the bag clip (q) from the feed hose.
2. Twist the bag connector until it disengages with
a clicking sound from the vacuum tube and
remove the filter bag.
3. Open the zipper and empty out the debris.
4. To replace the bag, align the markings on the
connector and the vacuum tube.
5. Click the connector into position on the vacuum
tube and reattach the bag clip to the hose.
2
Clean the In-Line Filter
To clean the in-line filter screen:
1. Remove the filter screen from the
assembly, as shown.
2. Rinse with clean water.
3. Press the filter screen firmly back in
place and tighten assembly.
3
Storage/Winterizing
NOTE: Never store the cleaner in direct sunlight.
To store the cleaner for the winter:
1. Remove cleaner from the pool and drain all water to avoid freezing water damage
(freeze damage is not covered under the warranty).
2. Remove the UWF from the pool wall using the Quick Disconnect. Use a pulling
pressure as you unscrew.
If necessary, use the UWF Removal Tool (part #10-102-00) available from
any Polaris dealer.
®
q
Zipper
Closure
Bag Collar
11